Modem
Reference Manual for EL470 IP Satellite Modem
Command
IfBBRXChannelDrop
BB RX Channel
Dropped
BB RX Channel Dro
Location /Modem/Monitor/Interfaces/Ethernet
Description
Readout of the number of frames dropped during reception from a channel
queue inside FPGA. Frames are dropped when the reception buffer risks
overflow. This prevents the traffic streams from interfering with each other.
This counter accounts for either DVB-S2 baseband frames or DVB-S
transport stream frames dependant on the MdProcMode setting and
queue type.
The index identifies the queue.
Index 1 = Ethernet Rx traffic (baseband frames or transport stream).
Index 2 = ASI 1 Tx traffic (transport stream).
Index 3 = ASI 2 Tx traffic (transport stream).
Index 4 = ASI 3 Tx traffic (transport stream).
RMCP
Command
chd
array : [1 .. 5]
Access Normal user : R
Expert user : R
SNMP Table ntcDevsMod01InterfaceExtEntry
Command ntcDevsMod01IfBBRXChannelDrop
OID 1.3.6.1.4.1.5835.3.1.4000.1.6.1.1.[1 .. 5]
Values GUI Unit
Frames
Cmd Unit Factory Default (CU)
Frames 0
Expert Range (CU)
0 .. 4294967295
/Modem/Monitor/Interfaces/Ethernet/Packet Mon
Only valid for DVB-S2 modes.
Command
IfPacketLogAction
Action Action
Location /Modem/Monitor/Interfaces/Ethernet/Packet Mon
Description
Packet log action: configure the action taken when a packet is logged.
These are the options:
• Log binary.
• Log decoded: In a more readable format, showing IP addresses
etc...
• Counting: Packet counter + bitrate.
• Rx to packet monitor: This option extracts the traffic to the packet
monitor.
RMCP
Command
pla Access Normal user : no access
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfPacketLogAction
OID 1.3.6.1.4.1.5835.3.1.4.1.219.1.1
Values Factory Default
logBinary
Enumeration Value
Log binary
Log decoded
0
1
version 3.1
125
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS
To Next Page
Loading...
