Newtec EL470 - Page 190

Modem Reference Manual for EL470 IP Satellite Modem
Command
IfGBSSettingsCRC
CRC CRC
Used as
variable of
Command(s)
IfGBSSettings
Page
59
Description
Configuration of the CRC calculation in case of XPE encapsulation or
decapsulation:
• Enabled: CRC calculation is used.
• Disabled: No CRC calculation is used.Remark: When CRC
calculation is disabled, the CRC is not send over the link.
RMCP
Command
IGc Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfGBSSettingsCRC
OID 1.3.6.1.4.1.5835.3.1.4.1.92.1.1
Values Factory Default
disabled
Enumeration Value
Enabled
Disabled
0
1
Command
IfGSESettingsDestMac
Air-MAC (6 byte label)
mode
Air-MAC (6 byte labe
Used as
variable of
Command(s)
IfGSESettings
Page
60
Description
GSE encapsulation label type mode:
• Air-MAC (6 byte label) enabled
• Air-MAC (6 byte label) disabled
RMCP
Command
gsl Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfGSESettingsDestMac
OID 1.3.6.1.4.1.5835.3.1.4.1.275.1.1
Values Factory Default
disabled
Enumeration Value
Disabled
Enabled
0
1
Command
IfStrConfigStreamId
Stream Id Stream Id
Used as
variable of
Command(s)
IfStrConfig
Page
79
Description
Configuration of the stream index for DVB-S2 stream configurations. This
is not the input stream identifier but the array index number used for
reference in the filter configurations.
RMCP
Command
ISi Access Normal user : RW
Expert user : RW
version 3.1
183
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS