Newtec EL470 - Page 21

Unit Menu Reference Manual for EL470 IP Satellite Modem
Command
SyDevUptime
System uptime System uptime
Values Factory Default String Description
length : 0 .. 128
format : any chars
/Unit/Setup/Serial port settings
Command
SyDevSerIfType
Serial M&C interface
type
Serial interf. type
Location /Unit/Setup/Serial port settings
Description
Configuration of the monitoring and control serial port interface type:
RS485 (default) or RS232.
RS232 is used for monitoring and control of a single device.
RS485 is typically used for multiple devices on a single bus.
RMCP
Command
SIT Access Normal user : no access
Expert user : RW
SNMP Table ntcDevsMod01SystemEntry
Command ntcDevsMod01SyDevSerIfType
OID 1.3.6.1.4.1.5835.3.1.1.1.29.0.1
Values Factory Default
rs485
Enumeration Value
RS485
RS232
0
1
Command
SyDevRs485Addr
Device address for
serial interface
Device RMCP address
Location /Unit/Setup/Serial port settings
Description
Configuration of the device address for the serial interface. The device
address, used in the messages for remote serial management and control,
is a single byte with a value in the range 49 (31 hex - ASCII "1") up to 110
(6E hex - ASCII "n"). It identifies the device that has to handle the
message from the remote control unit.
When the multi-user RS485 bus is used, each device on the bus must
have a different address, unique in the system.
Address 111 (6F hex - ASCII "o") is the "broadcast" address. This can be
used when only one device is connected to a COM-port of a PC to
address the device without knowing its exact address.
RMCP
Command
Adr Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01SystemEntry
Command ntcDevsMod01SyDevRs485Addr
OID 1.3.6.1.4.1.5835.3.1.1.1.27.0.1
Values GUI Unit
NA
Cmd Unit Factory Default (CU)
NA 50
Expert Range (CU)
49 .. 110
version 3.1
14
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS