Unit Menu
Reference Manual for EL470 IP Satellite Modem
/Unit/Setup/Display settings
Command
SyDevDispContrast
Display contrast Display contrast
Location /Unit/Setup/Display settings
Description
Configuration command to adjust the display contrast. Use the +/- keys on
the front panel to adjust the display contrast..
RMCP
Command
dpc Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01SystemEntry
Command ntcDevsMod01SyDevDispContrast
OID 1.3.6.1.4.1.5835.3.1.1.1.10.0.1
Values GUI Unit
units
Cmd Unit Factory Default (CU)
units 50
Expert Range (CU)
0 .. 100
Command
SyScreenSaveDly
Screensaver delay Screensaver delay
Location /Unit/Setup/Display settings
Description
Configuration of the screensaver delay. The screensaver delay is the
number of minutes of inactivity that is needed before the screensaver is
displayed. The screensaver is disabled if this time is set to 0.
RMCP
Command
SSt Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01SystemEntry
Command ntcDevsMod01SyScreenSaveDly
OID 1.3.6.1.4.1.5835.3.1.1.1.55.0.1
Values GUI Unit
min
Cmd Unit Factory Default (CU)
min 10
Expert Range (CU)
0 .. 1440
Command
SyScreenSaveMsg
Screensaver message Screensaver message
Location /Unit/Setup/Display settings
Description
Configuration of the screensaver message. The screensaver message is
the text to be displayed when the screensaver is active. Typically a device
or channel identification is used (e.g. MOD_1, BBC1, HB_9, CH1,...). The
maximum length of this text is 20 characters. When the screensaver is
activated the display will show this text together with the last configuration
that has been loaded.
RMCP
Command
SSm Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01SystemEntry
Command ntcDevsMod01SyScreenSaveMsg
OID 1.3.6.1.4.1.5835.3.1.1.1.56.0.1
version 3.1
17
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS
To Next Page
Loading...
