Alarms
Reference Manual for EL470 IP Satellite Modem
Special Command
AlAlarmsMem
Memorised alarm
string
Mem. al. string
Location /Config
Description
Readout of the concatenated string describing the state of all individual
memorised alarm counters.
• 0: Indicates that the respective counter did not count any alarm
events since last reset.
• 1: Indicates that the respective counter did count alarm events since
last reset.A get request returns the memorised alarm counter status.
The counters are not reset. A set command returns the memorised
alarm counter status and resets the counters.Remark: The number
of events can be retrieved with the individual counter reading
command AlAlarmMem.
RMCP
Command
MAs Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01AlarmEntry
Command ntcDevsMod01AlAlarmsMem
OID 1.3.6.1.4.1.5835.3.1.2.1.10.0.1
Get Command Arguments Set Command Arguments
Command(s) / Variable(s) Page Command(s) / Variable(s) Page
none none none none
Get Reply Values Set Reply Values
Command(s) / Variable(s) Page Command(s) / Variable(s) Page
AlAlarmString
231
AlAlarmString
231
Special Command
AlAlarmsMode
Alarm mode string Alarm mode string
Location /Config
Description
Configuration of the current alarm modes for all device alarms. The alarm
mode provides more detailed information about the current alarm status. It
indicates if the alarm is operational, masked by the operator or
suppressed by system state, priority or capability limitations. The
command returns the concatenated string of all individual alarm mode
replies.
The different options are :
• Normal : Selects "normal" operational behaviour.
• Masked : A masked alarm is continuously kept in the no alarm (0)
status.
• Forced : A forced alarm is continuously kept in the alarm (1)
status.The command argument consists of the concatenated string
of all individual control action words hence allowing individual control
of all alarms with this single command. The command always replies
with the concatenated string consisting of all individual current
control status words.Remark: The current and memorised alarms
are immediately cleared when an alarm is masked by the user.
RMCP
Command
CAm Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01AlarmEntry
Command ntcDevsMod01AlAlarmsMode
version 3.1
247
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS
To Next Page
Loading...
