Newtec EL470 - Page 30

Unit Menu Reference Manual for EL470 IP Satellite Modem
Command
SyDevActivate
Activate system file Activate system file
SNMP Table ntcDevsMod01SystemEntry
Command ntcDevsMod01SyDevActivate
OID 1.3.6.1.4.1.5835.3.1.1.1.82.1.1
Values Factory Default
none
Enumeration Value
None
All
0
1
Command
SyIntAlarmMaskMode
Interface alarm
masking mode
Interface alarm mask
Location /Unit/Control
Description
Configuration of the interface alarm masking mode. When the unit is
controlled via a universal switching system, the interface alarm relais
contact is used to determine the switch over. The interface alarm is a
group of alarms, thus each of these alarms can trigger the universal
switching system switch over. Due to the hardware set-up, it could be
desired to change the behaviour of the interface alarm relais contact by
masking some of the alarms. With this command some alarms in the
interface alarm group could be masked.
RMCP
Command
IAm Access Normal user : no access
Expert user : RW
SNMP Table ntcDevsMod01SystemEntry
Command ntcDevsMod01SyIntAlarmMaskMode
OID 1.3.6.1.4.1.5835.3.1.1.1.94.1.1
Values Factory Default
off
Enumeration Value
Off
Mod Input
Demod Lock
Demod Lock + Mod Input
0
1
2
3
Command
SyInputAlEscallation
Input alarm escallation Input alarm escallat
Location /Unit/Control
Description
This field is used to select if the input alarm needs to be escallated to an
interface alarm or not. An interface alarm can thus be used as a trigger for
redundancy switchover.
RMCP
Command
iae Access Normal user : no access
Expert user : RW
SNMP Table ntcDevsMod01SystemEntry
Command ntcDevsMod01SyInputAlEscallation
OID 1.3.6.1.4.1.5835.3.1.1.1.108.1.1
version 3.1
23
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS