Newtec EL470 - Page 29

Unit Menu Reference Manual for EL470 IP Satellite Modem
Command
SyDevGenerate
Generate selected
output file
Generate output file
Location /Unit/Control
Description
With this command certain output files can be generated by selecting the
required output type. The generated output file can be retrieved from
the \FTP\out directory. In case of errors, the error output log can found in
the \FTP\log directory. The generated files have by default the unit name
as file name. The file name can be changed, but it is not allowed to be
change the extension!
The following selections are available:
• Unit configuration file with extension cfg: This file stores all global
settings and all the user configurations. The file can be used for
archiving configuration, but it can also be uploaded to another device
by using the command SyDevActivate. The source unit (creation of
the configuration file) and the destination unit (activation of the
configuration file) do not explicitly need the same software version.
The settings not known by the destination unit will be deleted and
new settings not known by the source unit will derive the factory
default. Some differences in the configuration (capability differences)
between source and destination unit can result in deleting the
complete user configuration.
• Linear pre-distortion file with extension lp: All data relevant for
linear pre-distortion will be stored in one output file.
• Non-linear pre-distortion file with extension nlp: All data relevant
for non-linear pre-distortion will be stored in one output file.
RMCP
Command
GOf Access Normal user : no access
Expert user : RW
SNMP Table ntcDevsMod01SystemEntry
Command ntcDevsMod01SyDevGenerate
OID 1.3.6.1.4.1.5835.3.1.1.1.83.1.1
Values Factory Default
none
Enumeration Value
None
Unit Configuration
Linear Predistortion
Non Linear Predistortion
0
1
2
3
Command
SyDevActivate
Activate system file Activate system file
Location /Unit/Control
Description
Configuration command to process the selected output file. With this
command, all files found in the input directory (\FTP\In) will be processed if
the enumeration All is selected. The file name can be anything; only the
extension of the file will be used to identify the type of action. In case of
errors, the error output log can found in the \FTP\log directory.
The following types of input files are available:
• Unit configuration file with extension cfg.
• Linear pre-distortion file with extension lp.
• Non-linear pre-distortion file with extension nlp.
• RMCP command file (such as used for RMCP loader).Remark:
RMCP is the default behaviour if former extensions are not found.
RMCP
Command
AIf Access Normal user : no access
Expert user : RW
version 3.1
22
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS