Newtec EL470 - Page 53

Modem Reference Manual for EL470 IP Satellite Modem
/Modem/Control/Interfaces/Ethernet/Link/Interface
Only valid for Eth(IP), Eth(TSoIP), Eth(S2BBF) or Eth(ntS2BBF)
processing modes.
/Modem/Control/Interfaces/Ethernet/Link/Interface A
Command
IfEthAutoNegEn
Auto-Negotiation Auto-Negotiation
Location /Modem/Control/Interfaces/Ethernet/Link/Interface A
Description
Configuration of auto-negotiation of the Ethernet physical interface. When
auto-negotiation is disabled the correct speed must be configured via
command IfEthForceSpeed. If auto-negotiation is enabled, the auto-
negotiation sequence will be restarted.
Remark: For 1000 BASE-T, auto-negotiation must always be enabled.
RMCP
Command
EAe
array : [1 .. 2]
Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfEthAutoNegEn
OID 1.3.6.1.4.1.5835.3.1.4.1.81.1.1.[1 .. 2]
Values Factory Default
enabled
Enumeration Value
Disabled
Enabled
0
1
Command
IfEthAutoNegRestart
Restart Auto-
Negotiation
Restart Auto-Negotia
Location /Modem/Control/Interfaces/Ethernet/Link/Interface A
Description
Configuration command to restart the auto-negotiation sequence of the
Ethernet physical interface.
RMCP
Command
EAr
array : [1 .. 2]
Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfEthAutoNegRestart
OID 1.3.6.1.4.1.5835.3.1.4.1.82.1.1.[1 .. 2]
Values Factory Default
idle
Enumeration Value
Restart
Idle
0
1
Command
IfEthForceSpeed2
Speed advertisement Speed advertisement
Location /Modem/Control/Interfaces/Ethernet/Link/Interface A
Description
Configuration command to force the speed of the Ethernet physical
interface to a given bitrate by changing the advertised speeds in the auto-
version 3.1
46
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS