Newtec EL470 - Page 54

Modem Reference Manual for EL470 IP Satellite Modem
Command
IfEthForceSpeed2
Speed advertisement Speed advertisement
negotiation process.
RMCP
Command
efs
array : [1 .. 2]
Access Normal user : no access
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfEthForceSpeed2
OID 1.3.6.1.4.1.5835.3.1.4.1.232.1.1.[1 .. 2]
Values Factory Default
autonegotiated
Enumeration Value
autonegotiated
10 BASE-T Half Duplex
10 BASE-T Full Duplex
100 BASE-T Half Duplex
100 BASE-T Full Duplex
1000 BASE-T Full Duplex
0
1
2
3
4
5
/Modem/Control/Interfaces/Ethernet/Link/Interface B
Command
IfEthAutoNegEn
Auto-Negotiation Auto-Negotiation
Location /Modem/Control/Interfaces/Ethernet/Link/Interface B
Description
Configuration of auto-negotiation of the Ethernet physical interface. When
auto-negotiation is disabled the correct speed must be configured via
command IfEthForceSpeed. If auto-negotiation is enabled, the auto-
negotiation sequence will be restarted.
Remark: For 1000 BASE-T, auto-negotiation must always be enabled.
RMCP
Command
EAe
array : [1 .. 2]
Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfEthAutoNegEn
OID 1.3.6.1.4.1.5835.3.1.4.1.81.1.1.[1 .. 2]
Values Factory Default
enabled
Enumeration Value
Disabled
Enabled
0
1
Command
IfEthAutoNegRestart
Restart Auto-
Negotiation
Restart Auto-Negotia
Location /Modem/Control/Interfaces/Ethernet/Link/Interface B
Description
Configuration command to restart the auto-negotiation sequence of the
Ethernet physical interface.
RMCP
Command
EAr
array : [1 .. 2]
Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfEthAutoNegRestart
version 3.1
47
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS