Newtec EL470 - Page 55

Modem Reference Manual for EL470 IP Satellite Modem
Command
IfEthAutoNegRestart
Restart Auto-
Negotiation
Restart Auto-Negotia
OID 1.3.6.1.4.1.5835.3.1.4.1.82.1.1.[1 .. 2]
Values Factory Default
idle
Enumeration Value
Restart
Idle
0
1
Command
IfEthForceSpeed2
Speed advertisement Speed advertisement
Location /Modem/Control/Interfaces/Ethernet/Link/Interface B
Description
Configuration command to force the speed of the Ethernet physical
interface to a given bitrate by changing the advertised speeds in the auto-
negotiation process.
RMCP
Command
efs
array : [1 .. 2]
Access Normal user : no access
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfEthForceSpeed2
OID 1.3.6.1.4.1.5835.3.1.4.1.232.1.1.[1 .. 2]
Values Factory Default
autonegotiated
Enumeration Value
autonegotiated
10 BASE-T Half Duplex
10 BASE-T Full Duplex
100 BASE-T Half Duplex
100 BASE-T Full Duplex
1000 BASE-T Full Duplex
0
1
2
3
4
5
/Modem/Control/Interfaces/Ethernet/Itf redundancy
Command
IfEthIfRedunEnable
Eth itf redundancy Eth itf redundancy
Location /Modem/Control/Interfaces/Ethernet/Itf redundancy
Description
Configuration command to enable or disable Ethernet interface
redundancy. When Ethernet interface redundancy is enabled, Ethernet
interface A and B will behave as one virtual interface. Only one of the
physical interfaces will be active at a time. The configuration will move
from one interface to the other, as one takes over operation from the
other.
RMCP
Command
eir Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfEthIfRedunEnable
OID 1.3.6.1.4.1.5835.3.1.4.1.241.1.1
Values Factory Default
disabled
Enumeration Value
Disabled
Enabled
0
1
version 3.1
48
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS