Newtec EL470 - Page 57

Modem Reference Manual for EL470 IP Satellite Modem
Command
IfEthIfRedunFollowGw
Itf follows gateway Itf follows gateway
Location /Modem/Control/Interfaces/Ethernet/Itf redundancy
Description
Configuration for the interface link selection to choose the active link
where the gateway IP address(es) can be reached. When one of the
configured IP gateways is not reachable on one of the interfaces, it will
make the other interface active. Gateway detection is only performed on
the active link. After switching to the redundant link, the system will not try
to switch back to the original link unless if there is a problem on the new
active link.
RMCP
Command
irf Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfEthIfRedunFollowGw
OID 1.3.6.1.4.1.5835.3.1.4.1.242.1.1
Values Factory Default
disabled
Enumeration Value
Disabled
Enabled
0
1
/Modem/Control/Interfaces/Ethernet/Unit redundancy
Command
IfEthUnitRedunState
Unit redundancy state Unit redundancy stat
Location /Modem/Control/Interfaces/Ethernet/Unit redundancy
Description
This command allows to configure the unit as active or standby. The
Ethernet interfaces of a standby unit will not carry operational traffic.
RMCP
Command
eus Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfEthUnitRedunState
OID 1.3.6.1.4.1.5835.3.1.4.1.246.1.1
Values Factory Default
active
Enumeration Value
Standby
Active
0
1
version 3.1
50
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS