Newtec EL470 - Page 58

Modem Reference Manual for EL470 IP Satellite Modem
Command
IfEthUnitRedunVmac
Unit redun virtual MAC Unit redun virtual M
Location /Modem/Control/Interfaces/Ethernet/Unit redundancy
Description
Configuration command to enable virtual MAC addresses on the Ethernet
traffic ports. Units that backup each other should have the same IP
addresses and virtual MAC addresses when one goes down. Before
enabling virtual MAC addressing, you should configure the virtual reality
identifier that determines the virtual MAC address to be used (according to
the virtual router redundancy protocol standard). Ethernet interfaces that
backup each other should be assigned the same VR-ID or virtual reality
identifier.
RMCP
Command
euv Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfEthUnitRedunVmac
OID 1.3.6.1.4.1.5835.3.1.4.1.247.1.1
Values Factory Default
disabled
Enumeration Value
Disabled
Enabled
0
1
Command
IfEthUnitRedunVrrp
VRRP enable VRRP enable
Location /Modem/Control/Interfaces/Ethernet/Unit redundancy
Description
This value is used to enable or disable the use of the VRRP protocol to
check the presence of a redundant unit. It is used to avoid that 2 devices
would be enabled at the same time.
RMCP
Command
urv Access Normal user : no access
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfEthUnitRedunVrrp
OID 1.3.6.1.4.1.5835.3.1.4.1.255.1.1
Values Factory Default
enabled
Enumeration Value
Disabled
Enabled
0
1
Command
IfEthUnitRedunVridA
VR-ID Eth A VR-ID Eth A
Location /Modem/Control/Interfaces/Ethernet/Unit redundancy
Description
Configuration of the VR-ID or virtual reality identifier for Ethernet interface
A. Ethernet interfaces that backup each other should have the same VR-
ID. The VR-ID is a value between 1 and 255. It uniquely identifies a set of
redundant Ethernet interfaces on a LAN.
RMCP
Command
vra Access Normal user : RW
Expert user : RW
version 3.1
51
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS