Newtec EL470 - Page 59

Modem Reference Manual for EL470 IP Satellite Modem
Command
IfEthUnitRedunVridA
VR-ID Eth A VR-ID Eth A
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfEthUnitRedunVridA
OID 1.3.6.1.4.1.5835.3.1.4.1.248.1.1
Values GUI Unit
NA
Cmd Unit Factory Default (CU)
NA 1
Expert Range (CU)
1 .. 255
Command
IfEthUnitRedunVridB
VR-ID Eth B VR-ID Eth B
Location /Modem/Control/Interfaces/Ethernet/Unit redundancy
Description
Configuration of the VR-ID or virtual reality identifier for Ethernet interface
B. Ethernet interfaces that backup each other should have the same VR-
ID. The VR-ID is a value between 1 and 255. It uniquely identifies a set of
redundant Ethernet interfaces on a LAN.
RMCP
Command
vrb Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfEthUnitRedunVridB
OID 1.3.6.1.4.1.5835.3.1.4.1.249.1.1
Values GUI Unit
NA
Cmd Unit Factory Default (CU)
NA 2
Expert Range (CU)
1 .. 255
Command
IfEthUnitRedunFollowGw
Unit follows gateway Unit follows gateway
Location /Modem/Control/Interfaces/Ethernet/Unit redundancy
Description
Configuration for unit redundancy to choose the active unit where the
gateway IP address(es) can be reached. When one of the configured IP
gateways is not reachable on one of the units, it can make the other unit
active. Gateway detection is only performed on the active link. After
switching to the redundant unit, the system will not try to switch back to the
original unit unless if there is a problem on the new active unit.
RMCP
Command
urf Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfEthUnitRedunFollowGw
OID 1.3.6.1.4.1.5835.3.1.4.1.245.1.1
Values Factory Default
disabled
Enumeration Value
Disabled
Enabled
0
1
version 3.1
52
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS