Newtec EL470 - Page 60

Modem Reference Manual for EL470 IP Satellite Modem
/Modem/Control/Interfaces/Ethernet/IP encap-decap
Only valid for Eth (IP) processing modes.
Command
IfEthInputConf
Enable Ethernet itf Enable Ethernet itf
Location /Modem/Control/Interfaces/Ethernet/IP encap-decap
Description
Configuration of the interface to be used on the Ethernet board. When
Ethernet interface redundancy is enabled, interface A points to the virtual
interface on top of interface A and B. If you want to know which of both
interfaces is currently active on a redundant setup, you can look at the
monitoring page.
RMCP
Command
IIc Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfEthInputConf
OID 1.3.6.1.4.1.5835.3.1.4.1.84.1.1
Values Factory Default
noinput
Enumeration Value
None
Interface A
Interface B
0
1
2
Command
IfVLANSupport
VLAN Support VLAN Support
Location /Modem/Control/Interfaces/Ethernet/IP encap-decap
Description
Configuration of VLAN support.
• With VLAN support enabled (default), Ethernet filtering and
processing is based on VLAN tags.
• With VLAN support disabled (= native VLAN support in 801.1Q), all
traffic coming from the input interface is processed without looking at
any VLAN information. e.g. the Ethernet RX filters which have
different VLAN identifier and different destination MAC behave as if
they had the same VLAN identifier and that this imaginary VLAN
matched the Ethernet input interface.
RMCP
Command
IVS Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfVLANSupport
OID 1.3.6.1.4.1.5835.3.1.4.1.114.1.1
Values Factory Default
disabled
Enumeration Value
Disabled
Enabled
0
1
version 3.1
53
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS