Newtec EL470 - Page 62

Modem Reference Manual for EL470 IP Satellite Modem
Command
IfEnableL2routing
L2 routing L2 routing
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfEnableL2routing
OID 1.3.6.1.4.1.5835.3.1.4.1.230.1.1
Values Factory Default
enabled
Enumeration Value
Disabled
Enabled
0
1
Command
IfPromiscFlag
promiscuous mode promiscuous mode
Location /Modem/Control/Interfaces/Ethernet/IP encap-decap
Description
Readout of the promiscuous flag that indicates if the Ethernet interface is
receiving packets for all MAC addresses (= promiscuous) or only for its
own MAC address (= non-promiscuous).
RMCP
Command
prm Access Normal user : no access
Expert user : R
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfPromiscFlag
OID 1.3.6.1.4.1.5835.3.1.4.1.197.1.1
Values Factory Default
nonPromiscuous
Enumeration Value
Non-promiscuous
Promiscuous
0
1
Command
IfForcePromiscuous
Force promiscuous Force promiscuous
Location /Modem/Control/Interfaces/Ethernet/IP encap-decap
Description
Configuration to force packet reception from the Ethernet interface in
promiscuous mode which means accepting all MAC addresses from the
Ethernet physical interface. Normally, the system will decide automatically
whether the Ethernet physical interface should be in promiscuous mode or
not. Forcing the physical interface into promiscuous mode is useful for
troubleshooting, because it allows you to capture all packets that are
received on the wire.
RMCP
Command
fpr Access Normal user : no access
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfForcePromiscuous
OID 1.3.6.1.4.1.5835.3.1.4.1.192.1.1
Values Factory Default
automatic
Enumeration Value
Automatic
Force promiscuous
0
1
version 3.1
55
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS