Newtec EL470 - Page 69

Modem Reference Manual for EL470 IP Satellite Modem
Structured Command
IfEthQosRuleEntry
Eth RX QOS rule table Eth RX QOS rule tabl
IfEthQosRuleClassif
IfEthQosRulePrio
196
197
/Modem/Control/Interfaces/Ethernet/IP encap-decap/Signalling
Command
SySigIp
Signalling IP Signalling IP
Location /Modem/Control/Interfaces/Ethernet/IP encap-decap/Signalling
Description
Configuration of the signalling IP address. The signalling IP address is
used for various control functions such as ACM messaging.
RMCP
Command
sip Access Normal user : no access
Expert user : RW
SNMP Table ntcDevsMod01SystemEntry
Command ntcDevsMod01SySigIp
OID 1.3.6.1.4.1.5835.3.1.1.1.95.1.1
Values Factory Default
239.1.0.1
String Description
length : 0 .. 15
format : \d{1,3}\.\d{1,3}\.\d{1,3}\.\d{1,3}
Command
IfEnableModDemodSig
mod-demod signalling mod-demod signalling
Location /Modem/Control/Interfaces/Ethernet/IP encap-decap/Signalling
Description
Configuration command to enable or disable modulator to demodulator
signalling. This signalling traffic can be used to lock a DVB-S2
demodulator or for information sharing between modulator and
demodulator.
RMCP
Command
Mds Access Normal user : no access
Expert user : RW
SNMP Table ntcDevsMod01InterfaceEntry
Command ntcDevsMod01IfEnableModDemodSig
OID 1.3.6.1.4.1.5835.3.1.4.1.239.1.1
Values Factory Default
enabled
Enumeration Value
Disabled
Enabled
0
1
version 3.1
62
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS