Modem
Reference Manual for EL470 IP Satellite Modem
Variable
IfEthQosRuleClassif
classifier classifier
ip.tos==8,16
ip.dscp==8-16
ip.dscp==8,16
ip.src==1.2.3.4
ip.dst==1.2.3.4
Values Factory Default String Description
length : 0 .. 30
format : any chars
Variable
IfEthQosRulePrio
Priority Priority
Used as
variable of
Command(s)
IfEthQosRuleEntry
Page
61
Description
Variable that contains the quality of service priority that is associated to a
quality of service rule. Packets that are matched by a quality of service
rule gets this priority in the system. The priority is used for admission
control decisions and as scheduling priority. It is not used for re-tagging
the priority values inside a packet.
Values Factory Default
lowest
Enumeration Value
Lowest
Low
High
Highest
0
1
2
3
Variable
MoAcmDmSupvIp
Demodulator IP Demodulator IP
Used as
variable of
Command(s)
MoAcmDmSupvEntry
Page
88
Description
Variable that contains the IP address of the demodulator device that is
supervised by the ACM controller.
Values Factory Default
0.0.0.0
String Description
length : 0 .. 15
format : \d{1,3}\.\d{1,3}\.\d{1,3}\.\d{1,3}
Variable
MoAcmDmSupvStrid
DVB-S2 Stream Id DVB-S2 Stream Id
Used as
variable of
Command(s)
MoAcmDmSupvEntry
Page
88
Description
Variable that contains the DVB-S2 stream identifier. The DVB-S2 stream
identifier should be modified depending on the receive conditions of the
modulator. This field is only applicable in multi-stream modulation mode.
Values GUI Unit
NA
Cmd Unit Factory Default (CU)
NA 1
Expert Range (CU)
0 .. 35
version 3.1
197
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS
To Next Page
Loading...
