Newtec EL470 - Page 95

Modem Reference Manual for EL470 IP Satellite Modem
/Modem/Control/Modulation/ACM control/Demod table
Structured Command
MoAcmDmSupvEntry
ACM demodulator
supervision table
Demod table
Location /Modem/Control/Modulation/ACM control/Demod table
Description
Configuration of the demodulator supervision parameters for the ACM
controller. The demodulator supervision parameters provides the mapping
between modulator and demodulator based on the demodulator IP
address and the DVB-S2 stream identifier.
RMCP
Command
dse
array : [1 .. 32]
Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01ModulatorEntry
Command ntcDevsMod01MoAcmDmSupvEntry
OID 1.3.6.1.4.1.5835.3.1.3.1.131.1.1.[1 .. 32]
Variables
MoAcmDmSupvIp
MoAcmDmSupvStrid
Page
197
197
/Modem/Control/Modulation/PHY
Only valid for DVB-S2.
Command
MoPLSSignature
Physical Layer
Scrambler signature
PLS signature
Location /Modem/Control/Modulation/PHY
Description
Configuration of the physical layer scrambler that scrambles all of the
physical layer frames except for their header parts. The sequence is reset
at the start of the frame body.
The physical layer scrambler signature assumes values in the range 0 and
262141.
In case of broadcasting services, the default PLS signature (value = 0)
shall be used to avoid manual receiver setting or synchronisation delays.
RMCP
Command
PSS Access Normal user : no
access
Expert user : RW
SNMP Table ntcDevsMod01ModulatorEntry
Command ntcDevsMod01MoPLSSignature
OID 1.3.6.1.4.1.5835.3.1.3.1.77.1.1
Values GUI Unit
NA
Cmd Unit Factory Default (CU)
NA 0
Expert Range (CU)
0 .. 262141
version 3.1
88
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS