GEO S12 GENERAL SET-UP INSTRUCTIONS Page 13/112
2.1.4 Example:
• GEO S12 has a 16 Ohms nominal impedance in passive mode, so 4x Geo S12 wired in parallel
will present a 16/4 = 4 Ohm load impedance. The maximum acceptable 2x2.5 mm
2
(AWG #12)
cable length L
max
for such a cluster is 10 meters.
IMPORTANT
Long speaker cables induce capacitive effects – up to hundreds of pF depending on the
quality of the cable - with a high-pass effect on high frequencies. If long speaker cables
must be used, ensure that they do not remain coiled while in use.
CONNECTOR PANEL PASSIVE MODE ACTIVE MODE
B
A
D
C
B
D
A
C
To Next Page
Loading...
Need help?
General
