Nibe SMO 40 - Symbols in the Display

Symbols in the display
The following symbols can appear in the display during operation.
DescriptionSymbol
This symbol appears by the information sign if there is informa-
tion in menu 3.1 that you should note.
These two symbols indicate if the compressor in the outdoor
module or the additional heat in the installation is blocked via
SMO 40.
These can, for example, be blocked depending on which oper-
ating mode is selected in menu 4.2, if blocking is scheduled in
menu 4.9.5 or if an alarm has occurred that blocks one of them.
Blocking the compressor.
Blocking additional heat.
This symbol appears if periodic increase or lux mode for the hot
water is activated.
This symbol indicates whether "holiday setting" is active in 4.7.
This symbol indicates whether SMO 40 has contact with NIBE
Uplink.
This symbol indicates the actual speed of the fan if the speed
has changed from the normal setting.
Accessory needed.
This symbol is visible in installations with active solar accessor-
ies.
This symbol indicates whether pool heating is active.
Accessory needed.
This symbol indicates whether cooling is active.
Heat pump with cooling function required.
15Chapter 2 | The control module – the heart of the houseNIBE SMO 40