Nibe SMO 40 - Advanced

TIP
Set the stop time earlier than the start time so that the period extends
beyond midnight. Scheduling then stops at the set stop time the day
after.
Scheduling always starts on the date that the start time is set for.
Caution
A significant change over a longer period of time may cause poor indoor
environment and worse operating economy.
ADVANCED
advanced 1.9
heating curve
external adjustment
min. flow line temp.
room sensor settings
cooling settings
fan return time
Menu advanced has orange text and is
intended for the advanced user. This
menu has several sub-menus.
curve Setting the curve slope for heat-
ing and cooling.
external adjustment Setting the heat
curve offset when the external contact
is connected.
min. flow line temp. Setting minimum
permitted flow line temperature.
Menu
1.9
room sensor settings Settings regarding the room sensor.
cooling settings Settings for cooling.
fan return time Fan return time settings in the event of temporary ventilation
speed change.
own curve Setting own curve for heating and cooling.
point offset Setting the offset of the heating curve or cooling curve at a specific
outdoor temperature.
night cooling Setting night cooling.
NIBE SMO 40Chapter 3 | SMO 40 – at your service32