Nibe VVM 320 Installer Manual

A
Accessibility, electrical connection, 27
Accessories, 69
Alarm, 67
Assembly, 8
B
Back button, 46
C
Cable lock, 28
Commissioning and adjusting, 39
Commissioning without heat pump, 41
Filling and venting, 39
Pool, 44
Post-adjustment, venting, 41
Preparations, 39
Setting hot water circulation, 44
Setting the cooling/heating curve, 42
SG Ready, 45
Start guide, 40
Start-up and inspection, 40
Commissioning without heat pump, 41
Compatible Air/water heat pumps, 7
Connecting accessories, 37
Connecting ACS 310, 23
Connecting cold and hot water, 21
Connecting EMK 300, 22
Connecting external operating voltage for the control
system, 29
Connecting hot water circulation, 23
Connecting pool, 24–25
Connecting the climate system, 21
Connecting to heat pump, 21
Connection as electric boiler, 21
Connection of external electrical addition, 22
Connection of external heat source, 22
Connection of integrated cooling in 4-pipe system, 23
Connections, 29
Control, 46, 50
Control - Introduction, 46
Control - Menus, 50
Control - Introduction, 46
Display unit, 46
Menu system, 47
Control knob, 46
Control - Menus, 50
Menu 5 - SERVICE, 53
Cooling mode indication, 35
Country specific information, 5
D
Delivery and handling, 8
Assembly, 8
Installation area, 8
Removing the covers, 10
Supplied components, 9
Transport, 8
Dimensions and pipe connections, 17
Display, 46
Display unit, 46
Back button, 46
Control knob, 46
Display, 46
OK button, 46
Status lamp, 46
Switch, 46
Disturbances in comfort, 67
Alarm, 67
Manage alarm, 67
Troubleshooting, 67
Draining the climate system, 39, 64
Draining the hot water heater, 63
E
Electrical addition - maximum output, 32
Power steps of the immersion heater, 32
Electrical circuit diagram, 1 x 230 V, 74
Electrical connections, 26, 31
Accessibility, electrical connection, 27
Cable lock, 28
Communication, 31
Connecting accessories, 37
Connecting external operating voltage for the control
system, 29
Connections, 29
Electrical addition - maximum output, 32
External connection options (AUX), 34
General, 26
Load monitor, 34
Miniature circuit-breaker, 27
NIBE Uplink, 34
Optional connections, 34
Outdoor sensor, 30
Power connection, 29
Removing the cover, base board, 28
79Item registerNIBE VVM 320
Item register

Nibe VVM 320 Specifications

General

Dimensions (HxWxD)	1800 x 600 x 615 mm
Power Supply	230 V
Frequency	50 Hz
Protection class	IP21
Compatible with	Nibe heat pumps
Display	Touch display
Smart Home Integration	Yes, via NIBE Uplink
Operating temperature	0°C to +45°C
Relative humidity	Max. 95 %
Type	Control unit for heat pumps