System: The climate system that the relevant schedule relates to is selected
here. This alternative is only displayed if there is more than one climate system.
Day: Select which day or days of the week the scheduling is to apply to here.
To remove the scheduling for a particular day, the time for that day must be reset
by setting the start time to the same as the stop time. If the row "all" is used, all
days in the period are set according to that row.
Time period: The start and stop time for the selected day for scheduling are se-
lected here.
Adjustment: How much the heating curve is to be offset in relation to menu 1.1
during scheduling is set here. If a room sensor is installed, the desired room
temperature is set in °C.
Conflict: If two settings conflict with each other, a red exclamation mark is dis-
played.
TIP
If you wish to set similar scheduling for every day of the week start
by filling in “all” and then changing the desired days.
TIP
Set the stop time earlier than the start time so that the period extends
beyond midnight. Scheduling then stops at the set stop time the day
after.
Scheduling always starts on the date that the start time is set for.
Caution
Changes of temperature in accommodation take time. For example,
short time periods in combination with underfloor heating will not give
a noticeable difference in room temperature.
COOLING (ACCESSORY REQUIRED)
Here you can schedule when cooling is permitted in the accommodation for up
to two different time periods per day.
Menu
1.3.2
29Chapter 3 | VVM 320 – at your serviceNIBE VVM 320
To Next Page
Loading...
