Nibe VVM 320 - +Adjust

Caution
Night cooling can only be activated when house heating has been de-
activated. This is done in menu 4.2.
+ADJUST
- degree of effect
climate system 1
+adjust 1.9.11
- degree of effect
Setting range: 0.1 – 1.0
Default value: 0.5
Menu
1.9.11
Using +Adjust, the installation communicates with the underfloor heating’s
control centre* and adjusts the heating curve as well as the calculated supply
temperature according to the underfloor heating system.
Here you can activate the climate systems you want +Adjust to affect. You can
also set how much effect +Adjust is to have on calculated supply temperature.
The higher the value, the greater the effect.
*Support for +Adjust required
NOTE
+Adjust must first be selected in menu 5.4 ”soft inputs/outputs”.
45Chapter 3 | VVM 320 – at your serviceNIBE VVM 320