Nibe VVM 320 User Manual

NIBE UPLINK
request new connection string
serial number
nibe uplink 4.1.3.1
switch off all users
connection string
number of users
Here you can manage the installation's
connection to NIBE Uplink
(nibeuplink.com) and see the number of
users connected to the installation via the
internet.
A connected user has a user account in
NIBE Uplink , which has been given per-
mission to control and/or monitor your in-
stallation.
Request new connection string
To connect a user account on NIBE Uplink to your installation, you must request
a unique connection code.
Menu
4.1.3.1
1.
Mark “request new connection string" and press the OK button.
2.
The installation now communicates with NIBE Uplink to create a connection
code.
3.
When a connection string has been received, it is shown in this menu at
"connection string" and is valid for 60 minutes.
Disconnect all users
1.
Mark “switch off all users" and press the OK button.
2.
The installation now communicates with NIBE Uplink to release your install-
ation from all users connected via the internet.
NOTE
After disconnecting all users none of them can monitor or control your
installation via NIBE Uplink without requesting a new connection string.
57Chapter 3 | VVM 320 – at your serviceNIBE VVM 320

Nibe VVM 320 Specifications

General

Dimensions (HxWxD)	1800 x 600 x 615 mm
Power Supply	230 V
Frequency	50 Hz
Protection class	IP21
Compatible with	Nibe heat pumps
Display	Touch display
Smart Home Integration	Yes, via NIBE Uplink
Operating temperature	0°C to +45°C
Relative humidity	Max. 95 %
Type	Control unit for heat pumps