Nidec NE200 - Page 75

NE200/300 Series Drive User Manual
66 Chapter 5 List of Parameters
Code Description Setting range Default Modify
M
odbus
Address
constant power
output
F3.23 Reserved Reserved Reserved
Reserve
d
F3.24
Torque ref. terminal
single modulation
0.0~10% 0.00% ○ 0418H
F3.25
Torque ref. terminal
total modulation
0.0~100% 50% ○ 0419H
F3.26
Torque limit in
vector control
mode
0~300.0% 150.0% ○ 041AH
F3.27
Torque boost
cut-
off frequency in
torque control
mode
0.00~15.00Hz 12.00Hz ○ 041BH
F3.28
Torque boost
amount in torque
control mode
0.0~20.0% 15.0% ○ 041CH
F3.31
Synchronous motor
initial position
detection
0 ： Do not detect
1 ： Detect in power-
on
first run
2 ： Detect every time
2 ○ 041FH
F3.32
Synchronous motor
initial position
detection current
50~120% 90% ○ 0420H
F3.33
Initial position
detection pulse
width
0~1200us 0 ○ 0421H
F3.34
Initial position
detection pulse
width actual value
0~1200us 0 * 0422H
F3.35
Synchronous motor
braking torque limit
0.0~300.0% 150.0% ○ 0423H
F3.36
Synchronous motor
flux weaken mode
0 ：
Flux weaken mode
is invalid
0 ○ 0424H