NE200/300 Series Drive User Manual
180 Chapter 6 Parameter description
6.15 Operation interface & display group (FE)
FE.00 Parameter display Range: 0～1【0】
0: Normal 3-levels menu display
1: Only display modified parameters
Note:
In normal status, menu show as 3 levels. The parameters without
modification will be not shown while only showing the parameters modified,
the customer can be easy to look at them.
FE.01 MFK Key function selection Range: 0～7【0】
0: MFK inactive
1: JOG running
Used to start Jog running, the direction is set by function code F0.17。
2: FWD/REV switching
MFK key is used to switch the running direction between forward and
reverse. It is equivalent to modify F0.17, but it will not be saved when
power lost.
3: UP/DOWN clear
Used to Clear the frequency set by external terminals (UN/DOWN) ,
this is equal to the function of terminal “UP/DOWN clear command”。
4: Running command switch
MFK key is used to switch the run command mode between keypad
control and remote command control (terminal command channel or
serial communication command channel). And the current run
command mode must be terminal or communications, otherwise this
option is invalid
7: RUN for FWD, MFK for REV, STOP for STOP
FE.02 STOP key function selection Range: 0～3【2】
To Next Page
Loading...
