Nidec NE200 - Protection Parameters (FP)

NE200/300 Series Drive User Manual
184 Chapter 6 Parameter description
Record the real time temperature of the heat sink/IGBT.
FF.14
②
Flux current Range: -200.0～200.0°C
FF.15
③
Torque current Range: -200.0～200.0°C
FF.17 Accumulated kilowatt-hours
(Upper 16 bits)
Range: -200.0～200.0°C
FF.18 Accumulated kilowatt-hours
(Low 16 bits)
Range: -200.0～200.0°C
6.17 Protection Parameters (FP)
FP.00 User password Range: 0~9999【0】
Any non-zero number can be set as password to activate the protection
function. After this operation, password is required to access to Group PF.
Otherwise all parameters of Group PF cannot be accessed.
0000: Clear the previous setup user password and disable the password
protection function.
FP.01 Parameter write-in protection Range: 0~2【0】
0: All parameters are allowed to be modified
1: Only FP.01 and FP.03 can be modified
In addition to this function code and FP.03, all parameters can be read
but cannot be modified.
2: All parameters aren’t allowed read
In addition to this function code and FP.03, all parameters value is
shown as "0000" and cannot be modified, this can prevent irrelevant
person to check.