Nikon D7000 - MD.pcb.unit

󲩎󲨺󲨹󲨪󲨱󲨨󲨨󲨩󲨥󲩊󲨦󲨫󲨰󲨩󲨬󲨦󲨹
󲨥󲨘󲨹󲨩󲨰 󳉗 󲨼󲨯󲨨󲨨󲨨󲨘󲨥
#1005
#683×2
[Yellow]
[Black]
[Black]
[Red]
FPC
MD PCB unit
・
Mount the MD PCB unit (#1005).
・
Tighten the two screws (#683).
・
Make solder bridges at two places to joint the MD PCB unit (#1005).
・
Solder the four wires.
・
Arrange the wires as shown in the below right picture.
Arrange the wires
along the guide.
Arrange the wires inside
the guide.
Make solder bridges ×
2 places
Pull the FPC out from the hole of
[#1005].
NICS