Height indication position of measurement-use sub-mirror
Tool (device)
J19132 J19132B J18389
Main/Sub mirror angle inspection
tool
measurement-use mirror
59
(for D300/D200
Reection mirror Hex. key wrenchwrench
φ 1.5 mm
Standard value of sub-mirrortandard value of sub-mirror
(59°angle [for D200/D300]
Up-down deviation
Left-right deviation
If the result does not meet the standard, make the adjustment by turning the below eccentric pin with the hex. key
Eccentric pin for up-down adjustment of
sub-mirror
NICS
To Next Page
Loading...
