Nikon DTM-522 - Page 159

5) Mode Key [MODE] ...................................................................3-25
1. While Inputting PT/CD ......................................................................3-25
2. Quick Code Mode (from BMS)..........................................................3-26
6) COD Key
[COD] .......................................................................3-27
1. Updating Default CD..........................................................................3-27
2. Qcode Observation.............................................................................3-27
3
OPERATION
7) HOT Key
[HOT]........................................................................3-28
1. Height of Target..................................................................................3-28
2. Temperature & Pressure .....................................................................3-28
3. Select Target-set..................................................................................3-28
4. Note....................................................................................................3-29
8) Level
[Bubble] .........................................................................3-30
9) Lumi-guide On/Off
[LG] ............................................................3-31
3-4. Applications ....................................................................... 3-32
1) HA Reset and Angle Operations [ANG] ...................................3-32
1. 0-Set
Setting the Horizontal Angle to 0 .......................................................3-32
2. Input
Inputting the Horizontal Angle...........................................................3-32
3. Rept.
Recording a Foresight Point after Repeat Angle Measurement..........3-33
4. F1/F2
Face1/Face2 Measurement.................................................................3-34
5. Hold
Horizontal Angle Hold........................................................................3-34
2) Instrument Station Setup
[STN]................................................3-35
1. Known Stn
Station Setup with Known Coordinates or Azimuth...........................3-35
1-1. 1: Known→1:Coord
Sighting the BS (backsight) Point by Inputting Coordinates.....3-36
1-2. 1:Known→2:Angle
Sighting the BS (backsight) Point by Inputting Azimuth
Angle.........................................................................................3-38
2. Multiple Point Resection
Setup Station by Angle/Distance Measurements to Known Points ....3-39
3. Quick Station (Quick)
Setup the Station Quickly without Given Coordinates.......................3-43
4. Remote Benchmark (RBM)
Determine Station Elevation...............................................................3-44
ii