3
OPERATION
5. BSCheck (BSChk)
Check and Reset the Backsight Direction...........................................3-45
3) Stakeout
[S-O]..........................................................................3-46
1. Ang-Dist (HD-HA)
Specifying the Stakeout Point Position by Angle and Distance..........3-46
2. Input XYZ
Specifying the Stakeout Point Position by Coordinates......................3-48
3. DivLine S-O .......................................................................................3-52
4. RefLine S-O........................................................................................3-53
4) Program Key
[PRG]..................................................................3-55
1. 2-Pt Reference Line
Measuring Distance and Offset Values along a Specified Line ..........3-55
2. Arc-Curve Reference Line (Arc)
Measuring Distance and Offset Values on the Arc-Curve ..................3-58
3. Remote Distance Measurement..........................................................3-60
3-1. RDM (Radial)
Measuring between the Current and the First Point
Measured ...................................................................................3-60
3-2. RDM (Cont.)
Measuring between the Current Point and
the immediately Preceding Point...............................................3-62
4. Remote Elevation Measurement.........................................................3-63
5. 2-Pt Reference Plane (V-Pln)
Measuring Distance and Offset Values on the Vertical Plane.............3-64
6. 3-Pt Reference Plane (S-Pln)
Measuring Distance and Offset Values on the Slope..........................3-66
5) Recording Measurement Data
[REC/
ENT
].................................3-68
1. Recording Data from any Observation Screen ...................................3-68
2. Outputting Data to the COM Port.......................................................3-69
6) Offset Measurements
[O/S]....................................................3-70
1. Tape Offset Measurements .................................................................3-70
2. Angle-Offset Measurements...............................................................3-72
3. Two-Prism Pole ..................................................................................3-73
4. Line Extension by Horizontal Angle Offset........................................3-74
5. Horizontal Distance Input after Angle-only Shot ...............................3-76
6. Calculate the Corner Point..................................................................3-77
7. Circle Offset Measurements ...............................................................3-79
8. Extend Slope Distance........................................................................3-81
7) USR Key
[USR1]/ [USR2] .......................................................3-82
8) DAT Key [DAT] .........................................................................3-84
iii
To Next Page
Loading...
