Nikon Eclipse 50i - Recharging Battery (ECLIPSE 55 i)

Chapter 4 Assembly
70
13
Installing the Power Cord
13-1 For the 50i:
(1) Check to confirm that the microscope power switch is off.
(2) Insert one end of the power cord into the AC inlet at the back of the microscope.
(3) Insert the other end of the power cord into a wall outlet.
13-2 When using the cytodiagnostic unit with the 50i
(1) Check to confirm that the cytodiagnostic unit
power switch is off.
(2) Connect one end of the power cord to the AC
adapter connecting to the cytodiagnostic unit.
Use only the specified AC adapter and power
cord.
(3) Insert the other end of the power cord into a
wall outlet.
13-3 When not using the battery with the 55i:
(1) Check to confirm that the microscope power
switch is off.
(2) Connect one end of the power cord to the AC
adapter leading out from the wiring section on
the back of the microscope.
Use only the specified AC adapter and power
cord.
(3) Insert the other end of the power cord into a
wall outlet.
Microscope assembly is now complete.
Power switch for
the microscope
AC inlet
Power cord
AC ada
p
ter