Chapter 3 Individual Operations
171
Individual
Operations
Operation Button Function
Operation
Reference in DS-L3
Instruction Manual
[SHUTTER INTSL]
Open/close the built-in shutter in
the HG precentered fiber
illuminator. (Equivalent to the
[SHUTTER INTSL] button on the
[INTSL] sub screen.)
Chapter 5 “1.12.1
Opening/closing the
Motorized HG Precentered
Fiber Illuminator's Built-in
Shutter”
[SHUTTER EPI]
Open/close the EPI motorized
shutter.
[SHUTTER DIA]
Open/close the DIA motorized
shutter.
[SHUTTER]
[SHUTTER AUX]
Open/close the AUX motorized
shutter.
Chapter 5, “1.16
Opening/Closing the
EPI/DIA/AUX Motorized
Shutter”
[CAPTURE FRONT]
Output the capture trigger signal
to the digital camera connected to
the tube adapter.
[CAPTURE LEFT]
Output the capture trigger signal
to the digital camera connected to
the DSC zooming port.
[CAPTURE]
[CAPTURE AUX]
Output a capture trigger signal to
a digital camera connected to the
position other than the above.
Chapter 5, “1.17 Outputting
Capture Trigger Signals from
the Microscope”
[SAVE MODE]
Save the current microscopy state
as a mode.
Chapter 5, “2.2
Saving/updating a Mode
(State of Motorized
Devices)”
[LOAD MODE]
[LOAD (MODE number)]
Load a saved mode.
Chapter 5, “2.3 Loading a
Mode”
[Z-axis RESET]
Reset the Z-axis coordinate
displayed on DS-L3 to zero (0).
Chapter 5, “1.18.1
Zero-resetting the Z-axis
Coordinate”
[ESCAPE]
Move the microscope's elevating
section to the retracting position.
Press the button again to restore
it to the original position.
Chapter 5, “1.18.2
Retracting the Elevating
Section”
[XYZ]
[Specimen Removal Position]
Move the microscope's elevating
section to the retracting position,
and the motorized XY stage to the
sample removal position (front).
When you press this button again,
only the motorized XY stage
returns to its original position.
Chapter 5, “1.18.3
Retracting the Elevating
Section and Moving the
Stage to the Sample
Removal Position”
To Next Page
Loading...
