EasyManuals Logo

nilan CTS602I HMI Installation Instructions

nilan CTS602I HMI
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
Warnings and rules
Not areas of application
CAUTION
The unit must not be used for extraction of chips or where there is a risk of explosive gases.
No duct connection
ATTENTION
If one or more of the spout are not connected to a duct, a protective net with a mesh width of
not more than 20 mm must be mounted on this / these.
Opening the unit
CAUTION
Do not open the service doors until the power switch is turned off and the fans have stopped.
Unit in pause mode
ATTENTION
When a ventilation unit is not in operation, humidity from the rooms may penetrate into the
ducts and create condensation. Condensate water may leak out of the valves and damage
furniture and floors. Condensation may also form inside the unit, which can damage its
electronics and fans.
VPM 120-560 (English) BY NILAN
7

Table of Contents

Other manuals for nilan CTS602I HMI

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the nilan CTS602I HMI and is the answer not in the manual?

nilan CTS602I HMI Specifications

General IconGeneral
Brandnilan
ModelCTS602I HMI
CategoryControl Unit
LanguageEnglish