Nilfisk-Advance SC3000 Service Manual

Solution System 101Service Manual – SC3000
Troubleshooting (continued)
Trouble Possible Causes Remedy
Small amount of EcoFlex ™ detergent or
no detergent reaches the brush
The detergent ow percentage is too low Check/change the percentage as
shown in the User Manual
The hydraulic circuit upstream of the detergent pump is
not triggered
Check if the hose is lled and, if
necessary, perform one or more
draining cycles
The pump (M1) is broken or there is an open in the
electrical connection
Replace the pump/repair the
electrical connection
There is foreign material/debris in the detergent tank
clogging the output hole
Clean the tank
There is debris in the detergent hoses clogging the
detergent ow
Clean the hoses
The detergent ow control push button is
malfunctioning
Check that the LED turns on,
otherwise replace the dashboard
electronic board (EB3)
The function electronic board (EB1) is faulty Replace
The display electronic board (EB2) is faulty Replace
The dashboard electronic board (EB3) is faulty Replace
The EcoFlex ™ detergent reaches the
brush also when the machine is off
The pump (M1) is broken Replace
The one-way valve is broken Replace
There is water in the EcoFlex ™ system
tank
The one-way valve is broken Replace
The EcoFlex™ system does not turn and
the LED does not turn on
The dashboard electronic board (EB3) is faulty Replace
The function electronic board (EB1) is not set for the
operation with EcoFlex™ system
If equipped, remove the jumper
wire (J8) on the back of the
electronic board
J8
J4

Nilfisk-Advance SC3000 Specifications

General

Brand	Nilfisk-Advance
Model	SC3000
Category	Scrubber
Language	English