Scrub System, Disc 85Service Manual – SC3000
Removal and Installation
Removing and Installing the Brush Deck
Disassembly
1. Drive the machine on a level oor or on a
hoisting system to facilitate the disassembly
procedures.
2. Remove the brushes/pad-holder.
3. Turn the ignition key to “I”.
4. Lower the brush/pad-holder deck by pressing the
scrub On/Off push button .
5. Turn the ignition key to “0”.
6. Disconnect the red connector (A).
7. Disconnect the solution hose union (B).
8. Remove the screw (C) and recover the nut.
9. Remove the safety pins (D).
10. Remove the mounting nut (E) and recover the
washer, then remove the brush/pad-holder deck
(F).
Assembly
11. Assemble the components in the reverse order of
disassembly.
B
D
A
C
F
E
P100574
To Next Page
Loading...
