Nilfisk-Advance SC3000

Solution System 99Service Manual – SC3000
EcoFlex™ system disabling procedure
In order to permanently disable the EcoFlex™ system, proceed as follows:
1. Turn off the machine by turning the ignition key (A) to “0”.
2. Lift the lever (B), then turn the ignition key (A) to “I”.
3. Release the lever (A) at least 8 seconds after turning on the machine.
After this procedure, the EcoFlex™ lever cannot be operated again (LED (C) off) and the detergent concentra-
tion level is the one which has been set.
In order to re-enable the system, repeat the steps 1 to 3.
Note: ThepermanentdisablingoftheEcoFlex™systemisstoredintomemoryevenafterthe
machineisturnedoff.
B
A
C
P100579