What does M8 Short mean on a Nilfisk-Advance Scrubber?
The most likely cause of M8 Short is a loose wire at the pump touching the other terminal. Swap the pump wires (pump 1 for 2) according to the color codes. If the controller thinks the same pump is faulty, then you know the short is in the wires. If the controller thinks the other pump is faulty, then you know that one of them is faulty.
What does LP1,2 Short mean on Nilfisk-Advance SC6000 36C and how do I fix it?
The most likely cause of LP1,2 Short is a short in the wires leading to the headlight due to chaffing or melting. Disconnect both headlights. If the condition clears, at least one of the headlights is faulty.
What does H1 Short mean for Nilfisk-Advance SC6000 36C?
The most likely cause of H1 Short is a damaged coil with an internal short. Check the coil resistance of the horn. If it is significantly below the normal coil resistance of 5.8 ?, then replace the horn.
What does H2 Short mean on my Nilfisk-Advance SC6000 36C?
The most likely cause of H2 Short is a damaged coil with an internal short. Check the coil resistance of the horn. If it is significantly below the normal coil resistance of 5.8 ?, then replace the horn.
What causes L2 Short in Nilfisk-Advance SC6000 36C and what should I do?
The most likely cause of L2 Short is a damaged solenoid with an internal short. Check the coil resistance of the solenoid. If it is significantly below the normal coil resistance of 126 ?, then replace the solenoid.
What causes L1 Short in Nilfisk-Advance SC6000 36C and how to fix it?
The most likely cause of L1 Short is a damaged solenoid with an internal short. Check the coil resistance of the solenoid. If it is significantly below the normal coil resistance of 108 ?, then replace the solenoid.
What to do if my Nilfisk-Advance Scrubber displays an M1 Overcurrent error?
Possible causes for the M1 Overcurrent error could be a short circuit or a locked motor rotor. Investigate for short circuits or check if the motor rotor is locked.
General| Model | SC6000 36C |
|---|---|
| Type | Scrubber |
| Power Source | Battery |
| Battery Voltage | 36 V |
| Brand | Nilfisk-Advance |
| Category | Scrubber |
| Sound Level | 65 dB |
| Brush Motor | 0.75 kW |
| Vacuum Motor | 1150 W |
| Drive Speed | 0 - 6 km/h |
| Productivity Rate | 3000 m²/h |
To Next Page