EasyManuals Logo

Nilfisk-Advance SC6500 40C User Manual

Nilfisk-Advance SC6500 40C
213 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #180 background imageLoading...
Page #180 background image
Wheel System, Non-traction 180Service Manual – SC6500
Removal and Installation
Warning! Before removing or reinstalling any machine components, make sure the key switch
is off and the key is removed from the machine.
Install wood blocking or chocks in front of and behind the front drive wheel to
prevent the machine from rolling.
Brake Cable Replacement
1. Remove the oor plate
to access the cable
assembly at the brake
pedal.
2. Loosen the Locknut on
the cable end Mounting
Bolt
, then remove the
Mounting Bolt and
cable end.
3. Loosen the cable
casing Anchor Nuts
and pull the cable
free from its mount
bracket on the chassis.
4. Locate a plastic Tie
Strap
on the lower left
side of the chassis at
midpoint, then cut the
Tie Strap to free the
cable at that point.
5. Unclip the cable Clevis
Yoke
at the left brake
caliper at the arm and
separate.
6. Loosen the cable
Anchor Locknuts at
the Equalizer Yoke
mounting bracket.
The cable assembly
is now completely
disconnected.
7. Attach a new cable to the end of the old cable at the brake pedal, then pull the old cable out and pull the
new cable through the chassis.
8. Follow the above steps in reverse to reconnect the cable.
9. Follow the steps in the Brake Cable Adjustment section below to adjust the brake for correct operation.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nilfisk-Advance SC6500 40C and is the answer not in the manual?

Nilfisk-Advance SC6500 40C Specifications

General IconGeneral
BrandNilfisk-Advance
ModelSC6500 40C
CategoryScrubber
LanguageEnglish

Related product manuals