© 2005-2016 Nira Control AB 95
6. Calibrate the Throttle Sensor such that the parameter reads 0% when
you take your foot off the gas pedal and 100% when you depress the
pedal fully. This can be done with the help of the “Accelerator
Calibration Wizard” in NIRA rk. If you want to calibrate the Throttle
Sensor manually, follow the steps below.
Set NIRA rk to advanced mode.
Look for the labels.
Engine Setup -> All Paramters-> App Ad Pot 1 & App Ad Pot 2
Make a note of the parameter values for App Ad Pot 1 & App Ad Pot
2 when the gas pedal is fully depressed and when you let go of the
pedal completely.
The notes should for App Ad Pot 1 & 2 for fully depressed throttle
should be transferred to
Engine Setup -> Sensors-> App Pot 1 Umsp & App Pot 2 Umsp
Make the corresponding transfer from notes for fully released throttle.
Enter the values in
Engine Setup -> Sensors-> App Pot 1 Umsp & App Pot 2 Umsp
Do Key Off & Key on.
Check Engine Setup -> All Paramters-> App Position
To Next Page
Loading...
