NKT Koheras BASIK - Page 8

8
CONTROL – Control panel ..................................................................................... 71
Wavelength ............................................................................................................71
Power mode ...........................................................................................................71
Current mode ....................................................................................................... 72
6 Software Development Kit ..............................................................................................73
Read/write registers ................................................................................................. 74
Tuning the wavelength .......................................................................................74
Setting the operating mode ..............................................................................74
Auto start ................................................................................................................74
Setting the emission delay ............................................................................... 75
Narrow and wide range setting ...................................................................... 75
Setting the wavelength modulation source ................................................. 76
Setting the wavelength modulation signal coupling ..................................77
Internal generator frequency ............................................................................78
Internal generator amplitude ............................................................................78
Internal generator signal waveform ................................................................78
Internal generator -signal output .................................................................... 79
Wavelength modulation on/off ........................................................................ 80
Trigger setting input/output ............................................................................. 80
Trigger indicates emission ................................................................................ 81
Trigger sawtooth wavelength modulation .................................................... 81
Readings ..................................................................................................................... 82
Errors and status indicators ................................................................................... 83
Status indicators .................................................................................................. 83
Error codes ........................................................................................................... 83
Graphing ..................................................................................................................... 83
Section 3 INSTALLING THE LASER 85
7 Mechanical Installation ....................................................................................................87
General ........................................................................................................................ 87
Standalone mounting .............................................................................................. 87