Switch the device on and off
To switch the device on or off, press and hold the power key.
If the device prompts for a PIN or a UPIN code, enter the code (displayed as
****), and select OK.
The device may prompt you to set the time and date. Enter the local time, select
the time zone of your location in terms of the time difference with respect to
Greenwich mean time (GMT), and enter the date. See "Time and
date," p. 51.
When you switch on your device for the first time and the device is in the
standby mode, you may be prompted to get the configuration settings from
your service provider (network service). For more information refer to Connect
to service provider support. See "Configuration," p. 60. See "Configuration
setting service," p. 12.
Standby mode
When the device is ready for use, and you have not entered any characters, the
device is in the standby mode.
Display
1 — Signal strength of the cellular network
Your device
19
Cyan
Magenta
Yellow
Black
file:/D:/temp/overmode/GUID-89DCE1F7-7FBF-406A-B7B2-EFBE6DD81560.20070504145158174.en1178280131751/en/1/GUID-FACEAA13-0984-49EC-B52F-
E61DA4535A75.xml Page 19 May 4, 2007 3:02:55 PM