5. Write text
Text modes
To enter text (for example, when writing messages) you can use traditional or
predictive text input.
When you write text, press and hold Options to toggle between traditional
text input, indicated by
, and predictive text input, indicated by . Not
all languages are supported by predictive text input.
The character cases are indicated by
, , and . To change the character
case, press #. To change from the letter to number mode, indicated by
,
press and hold #, and select Number mode. To change from the number to
the letter mode, press and hold #.
To set the writing language, select Options > Writing language.
Traditional text input
Press a number key, 2 to 9, repeatedly until the desired character appears. The
available characters depend on the selected writing language.
If the next letter you want is located on the same key as the present one, wait
until the cursor appears and enter the letter.
To access the most common punctuation marks and special characters,
repeatedly press the number key 1 or press * to select a special character.
Predictive text input
Predictive text input is based on a built-in dictionary to which you can also add
new words.
1. Start writing a word, using the keys 2 to 9. Press each key only once for one
letter.
Write text
26
Cyan
Magenta
Yellow
Black
file:/D:/temp/overmode/GUID-89DCE1F7-7FBF-406A-B7B2-EFBE6DD81560.20070504145158174.en1178280131751/en/1/GUID-FACEAA13-0984-49EC-B52F-
E61DA4535A75.xml Page 26 May 4, 2007 3:02:55 PM
To Next Page
Loading...
