E-mail application
The e-mail application uses a packet data connection (network service) to allow
you to access your e-mail account. This e-mail application is different from the
SMS e-mail function. To use the e-mail function on your device, you need a
compatible e-mail system.
You can write, send, and read e-mail with your device. Your device supports
POP3 and IMAP4 e-mail servers. This application does not support keypad tones.
Before you can send and retrieve any e-mail messages, you must obtain a new
e-mail account or use your current account. To check the availability of your e-
mail account, contact your e-mail service provider.
Check your e-mail settings with your e-mail service provider. You may receive
the e-mail configuration settings as a configuration message. See
"Configuration setting service," p. 12.
To activate the e-mail settings, select Menu > Messaging > Message
settings > E-mail messages. See "E-mail messages," p. 44.
Setting wizard
The setting wizard starts automatically if no e-mail settings are defined in the
phone.
To enter the settings manually, select Menu > Messaging > E-mail >
Options > Manage accounts > Options > New. The options for Manage
accounts allow you to add, delete, and change the e-mail settings. Make sure
that you have defined the correct preferred access point for the operator. See
"Configuration," p. 60.
The e-mail application requires an internet access point without a proxy. WAP
access points normally include a proxy and do not work with the e-mail
application.
Write and send an e-mail
You can write your e-mail message before connecting to the e-mail service; or
connect to the service first, then write and send your e-mail.
Messaging
34
Cyan
Magenta
Yellow
Black
file:/D:/temp/overmode/GUID-89DCE1F7-7FBF-406A-B7B2-EFBE6DD81560.20070504145158174.en1178280131751/en/1/GUID-FACEAA13-0984-49EC-B52F-
E61DA4535A75.xml Page 34 May 4, 2007 3:02:55 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
