Settings
45
• Use callback - This option allows a server to call you
back once you have made the initial call. Contact your
service provider to subscribe to this service.
• Callback type - The options are Use server no. / Use other
no.. Ask your service provider for the correct setting to
use; it will depend on the service provider’s
configuration.
• Callback number - Key in your game deck’s data phone
number which the dial back server uses. Usually, this
number is the data call phone number of your game
deck.
• Use PPP compression - When set to Yes, this option
speeds up the data transfer, if supported by the remote
PPP server. If you have problems with establishing a
connection, try setting this to No. Contact your service
provider for guidance.
Glossary: PPP (Point-to-Point Protocol) - a
common networking software protocol that enables
any computer with a modem and a phone line to
connect directly to the Internet.
• Use login script - The options are Yes / No.
• Login script - Insert the login script.
• Modem initialisation (Modem initialisation string) -
Controls your game deck using modem AT commands.
If required, enter characters specified by your GSM
network service provider or Internet service provider.
GPRS
Go to Settings→ Connection settings→ GPRS.
The GPRS settings affect all access points using a packet
data connection.
GPRS connection - If you select When available and you are
in a network that supports packet data, the game deck
registers to the GPRS network and sending text messages
will be done via GPRS. Also, starting an active packet data
connection, for example, to send and receive e-mail, is
quicker. If you select When needed, the game deck will use
a packet data connection only if you start an application
or action that needs it.
Access point - The access point name is needed when you
want to use your game deck as a packet data modem to
your computer. For more information on modem
connections, see p. 123.
Note: If there is no GPRS coverage and you have
chosen When available, the game deck will periodically
try to establish a packet data connection.
Data call
Go to Settings→ Connection settings→ Data call.
The Data call settings affect all access points using a data
call and high speed data call.
To Next Page
Loading...
