Settings
40
Call settings
Note: To change the settings for call diverting, go
to Menu→ Tools→ Call divert. See ‘Settings for call
diverting’, p. 20.
Send my caller ID
• This network service allows you to set your phone
number to be displayed (Yes) or hidden (No) from the
person to whom you are calling. Or, the value may be
set by your network operator or service provider when
you make a subscription (Set by network).
Call waiting: (network service)
• The network will notify you of a new incoming call
while you have a call in progress. Select: Activate to
request the network to activate call waiting, Cancel to
request the network to deactivate call waiting, or
Check status, to check if the function is active or not.
Automatic redial
• When this setting is activated, your game deck will
make a maximum of ten attempts to connect the call
after an unsuccessful call attempt. Press to
stop automatic redialling.
Summary after call
• Activate this setting if you want the game deck to
briefly display the duration and cost of the last call. To
show costs, the Call cost limit needs to be activated for
your SIM card. See p. 22.
Speed dialling
• Select On and the numbers assigned to the speed
dialling keys ( - ), can be dialled by pressing
and holding the key. See also ‘Assigning speed dialling
keys’, p. 54.
Anykey answer
• Select On, and you can answer an incoming call by
briefly pressing any key, except , , and
.
Voice message indicators: , , or is
shown if you have one or several voice messages.
Line in use (network service)
• This setting is shown only if the SIM card supports two
subscriber numbers, that is, two phone lines. Select
which phone line (Line 1 or Line 2) you want to use for
making calls and sending text messages. Calls on both
lines can be answered irrespective of the selected line.
Note: You will not be able to make calls if you
select Line 2 and have not subscribed to this network
service.
To prevent line selection, select Line change→ Disable if
supported by your SIM card. To change this setting, you
need the PIN2 code.
Tip: To switch between the phone lines, press and
hold in standby mode.
To Next Page
Loading...
