Nokia N-GAGE - Viewing Messages on a SIM Card; Cell Broadcast (Network Service); Service Command Editor

Messaging
84
• Deferred - You can set documents to be ‘on hold’ while
they are in Outbox. Scroll to a message that is being
sent and select Options→ Defer sending.
• Failed - The maximum number of sending attempts has
been reached. Sending has failed. If you were trying to
send a text message, open the message and check that
the Sending settings are correct.
Viewing messages on a SIM card
Before you can view SIM messages, you need to copy
them to a folder in your game deck.
1 In the Messaging main view, select Options→ SIM
messages.
2 Select Options→ Mark/Unmark→ Mark or Mark all to
mark messages.
3 Select Options→ Copy. A list of folders opens.
4 Select a folder and press OK. Go to the folder to view
the messages.
Cell broadcast
(network service)
In the Messaging main view, select Options→ Cell
broadcast.
Options in Cell broadcast:
Open, Subscribe /Unsubscribe, Hotmark / Unhotmark,
Topic, Settings, Help, and Exit.
You can receive messages on various topics, such as
weather or traffic conditions from your service provider.
For available topics and relevant topic numbers, contact
your service provider. In the main view you can see:
• the status of the topic: - for new, subscribed
messages and - for new, unsubscribed messages.
• the topic number, topic name, and whether it has been
flagged ( ) for follow-up. You will be notified when
messages belonging to a flagged topic have arrived.
Note: A packet data (GPRS) connection may
prevent cell broadcast reception. Contact your network
operator for the correct GPRS settings. For further
information on the GPRS settings, see ‘Packet data
(General Packet Radio Service, GPRS)’, p. 42.
Service command editor
In the Messaging main view, select
Options→ Service command.
You can send service requests, such as activation
commands for network services (also known as USSD
commands), to your service provider. For more information,
contact your service provider. To send a request:
• in standby mode or when you have an active call, key
in the command number(s) and press Send, or
• if you need to enter letters as well as numbers, select
Messaging→ Options→ Service command.