Nokia N-GAGE - Page 87

Messaging
87
retrieve the message later, set On receiving msg. to Retr.
immediately.
Reject message - if you want to reject multimedia
messages. The multimedia messaging centre will delete
the messages.
• Allow anon. messages - Select No, if you want to reject
messages coming from an anonymous sender.
• Receive adverts - Define whether you want to receive
multimedia message advertisements or not.
• Reports - Set to Yes, if you want the status of the sent
message (Pending, Failed, Delivered) to be shown in the
Log. See p. 21.
Note: Receiving a delivery report of a
multimedia message that has been sent to an e-
mail address might not be possible.
• Deny report sending - Choose Yes, if you do not want
your game deck to send delivery reports of received
multimedia messages.
• Message validity - If the recipient of a message cannot
be reached within the validity period, the message is
removed from the multimedia messaging centre. Note
that the network must support this feature. Maximum
time is the maximum amount of time allowed by the
network.
• Image size - Define the size of the image in a
multimedia message. The options are: Small (max. of
160*120 pixels) and Large (max. 640*480 pixels).
• Default speaker - Choose Loudspeaker or Handset, if you
want the sounds in a multimedia message to be played
through the loudspeaker or the earpiece. For more
information, see ‘Loudspeaker’, p. 13.
Settings for e-mail
Go to Messaging and select Options→ Settings→ E-mail.
Open Mailbox in use to select which mailbox you want to
use.
Options when editing e-mail
settings: Editing options, New mailbox, Delete, Help, and
Exit.
Settings for Mailboxes
Select Mailboxes to open a list of mailboxes that have been
defined. If no mailboxes have been defined, you will be
prompted to do so. The following list of settings is shown:
• Mailbox name - Write a descriptive name for the
mailbox.
• Access point in use (Must be defined) - The Internet
Access Point (IAP) used for the mailbox. Choose an IAP
from the list. For more information on how to create an
IAP, see also ‘Connection settings’, p. 41.
• My mail address (Must be defined) - Write the e-mail
address given to you by your service provider. The
address must contain the @ character. Replies to your
messages are sent to this address.
• Outgoing mail server: (Must be defined) - Write the IP
address or host name of the computer that sends your
e-mail.