Nordson 3100V Series - Page 33

Overview of System
Components
Applicator
1.
Pump
2.
Tank
3.
Air regulator
4. Filter
and drain valve
5.
Controls
Additional
System Components
6. Hose
7. Air-operated
gun
8. Solenoid valve
4
2
3
8
5
6
7
Daily Maintenance
1.
Clean
the
exterior suffaces
of the
applicator and
guns.
2.
Check the o-rings and
gaskets
for leaks.
3.
Flush
the manifold filter
as follows:
a. Reduce
the
pump
air
pressure
to 0.
b. Place
containers under
all
guns
and trigger the
guns
to relieve hydraulic
pressure.
c. Open the drain valve
over a container
by
turning the valve
counterclockwise.
Type A Manifold
TypeBorSManifold
d. lncrease
the
pump
air
pressure
until
a clean,
steady stream
of hot melt material flows
from
the drain valve.
e.
Close the drain valve.
f. Return
the
pump
air
pressure
to the normal
operating setting.
2
229717C
lssued 4/98